E03.00
INOVANCE
MD500-PLUS VFD
Overcurrent during deceleration
⚠ Olası Nedenler
- Grounded or short-circuited output circuit
- Auto-tuning not performed
- Excessively short deceleration time
- Inappropriate overcurrent stall suppression
- Braking unit and resistor not installed
- External interference
✓ Çözüm Adımları
- Check motor for short/open circuit
- Set motor parameters and perform auto-tuning
- Increase deceleration time (F0-18)
- Enable overcurrent stall suppression; adjust F3-18 to 120-150%; F3-20 to 20-40
- Install braking unit and braking resistor
- Check for external interference
Daha Karmaşık Bir Sorun mu?
Zeror.ai yapay zekası, orijinal üretici kılavuzlarından parametre numarasına kadar detaylı çözüm sunar. Canlı uzman desteği de mevcuttur.
Zeror AI ile Detaylı Analiz Et →