E002.2
INOVANCE
MD520 VFD
Software overcurrent
⚠ Olası Nedenler
- Output grounding
- Inter-phase short-circuit
- No parameter auto-tuning in vector control mode
- Encoder interference or wire breakage
- Output phase loss
- Current detection exception
- V/f control acceleration/deceleration time too short
- Encoder phase sequence error
- Model setting error
✓ Çözüm Adımları
- Check for output short-to-ground
- Check output side for short circuit
- Set motor parameters correctly and perform auto-tuning
- Check encoder cable connection and grounding
- Check cables are properly connected
- Contact after-sales service
- Enable overcurrent suppression; increase acceleration/deceleration time
- Change encoder direction if opposite
- Set AC drive model correctly
Daha Karmaşık Bir Sorun mu?
Zeror.ai yapay zekası, orijinal üretici kılavuzlarından parametre numarasına kadar detaylı çözüm sunar. Canlı uzman desteği de mevcuttur.
Zeror AI ile Detaylı Analiz Et →